Daewoo DWF-7588TE, Руководство по обслуживанию

Страница: 9 / 34

13 12
5. DIRECTIONS FOR INSTALLATION AND USE
HOW TO INSTALL THE WASHING MACHINE
SELECTION OF THE INSTALLING PLACE
Install the washer on a horizontal solid floor.
If the washer is installed on an unsuitable floor, it
could make considerable noise and vibration.
•
The proper installation of the washing
machine can increase the wash
effectiveness and the life of it.
INSTALLATION OF THE UNDER BASE COVER
HOW TO INSTALL ON AN INCLINED PLACE
Never install in these places
•
The place where it would be exposed to
direct sunlight.
•
The place nearby a heater or heat appliance.
•
The place where it would be supposed to be
frozen in winter.
•
The kitchen with coal gas and a damp place
like a bathroom.
1
\
Separate under
base cover from
the unit.
2
\
There is a
inserting place
under of the back
side on the
washer.
3
let the base cover
that can be shown
the “UP” sign.
4
Insert the base
cover into the slot
of under base until
come to the end
of the slot.
1
\
Height Setting
•
After controlling the height by
turning the adjustable leg, let the
washer put down to the ground.
2
Check the
Horizontal Status
•
Check the position of tub above the
center of the washer.
After installing the washing machine,
close the under-base cover.
If the washer is installed on an unsuitable floor, it could make
considerable noise and vibration, and could cause a
malfunction.
NOTES :
The openings must not be
obstructed by carpeting when
the washing machine is installed
on a carpeted floor.
HOW TO CONNECT THE INLET HOSE
IN INSTALLING THE INLET HOSE
Be careful not to mistake in supplying hot
and cold water.
In using only one water tap, connect the
inlet hose to the cold water inlet.
•
FOR SCREW-SHAPED TAP
NOTE
In a high water pressure, when start with a set-up of WARM-temperature WASH, it is desirable not to turn
the faucet on. High pressure may cause on overflow rinse.
1
\
Pull down the collar
of the inlet hose to
separate it from the
water tap adapter.
2
\
Loosen the four
screws at the water
tap adapter, but
don’t loosen the
screw until they are
separated from the
water tap adapter.
1
\
Connect the inlet hose to the water tap by
screwing the connector D tightly.
2
\
Connect the connector C of the inlet hose to
the water inlet of the washer by turning it
clockwise to fix it tightly.
• Please check the rubber
packing inside
the connector C
of the inlet hose
3
Connect the water
tap adapter to the
water tap, and
tighten the four
screws evenly
while pushing up
the adapter so
that the rubber
packing can stick
to the water tap
tightly.
4
\ Remove the
tape, and screw
connector B into
connector A
tightly.
5
\ Connect the inlet
hose to the
water tap
adapter by
pulling down the
collar of the hose
end.
6
\ Connect the inlet
hose adapter of
the hose to the
water inlet of the
washer by
turning is
clockwise to be
fixed tightly.
Water Tap
Adapter
Connector C
Rubber
packing
Connector D
Connector C
Inlet Hose
Rubber
Packing
Water
Tap
Adapter
Connector A
Connector B
Water Tap Adapter
Connector B
Collar
Connector A
Collar
•
For Ordinary Top
Tape
• Please check the rubber
packing inside the inlet
hose adapter of the
hose.