Daewoo DMB-1812LH, Руководство по обслуживанию

Страница: 79 / 95

76
PROCEDURES PHOTOS
1. Stop the Air conditioner and disconnect the power cord from the wall
outlet.
2. Removing the Insert Grille and Frame Grille. (Fig 1~2)
1
Draw up the Insert Grille and remove it.
2
Loosen two special screws fixed at the Cover Ter-Block.
3
Loosen three screws at the Body.
4
Remove the Frame Gille.
3. Removing the Control Box. (Fig 3)
1
Remove room and coil thermistors.
2
Disconnect the fan motor lead wire from connection at the
Control PCB.
3
Disconnect the stepping motor lead wire from connection at the
Control PCB.
4
Remove the select switch from connection at the Control PCB.
5
Loosen the screw fixed at the ground wire.
6
Remove the Control Box
4. Removing the Drain Pan. (Fig 4)
1
Disconnect the Body drain hole. (left and right Body)
2
Disconnect three hooks and remove the Drain Pan.
5. Removing the Indoor Evaporator. (Fig 5~6)
1
Remove three screws fixed at the indoor Evaporator of the Body.
2
Remove the hook fixed at the Bracket Pipe of the back of Body.
3
Remove Indoor Evaporator.
6. Removing the Cross Flow Fan. (Fig 7)
1
Remove set screw fixed at the Motor shaft.
2
Remove Cross Flow Fan.
7. Remove Motor IDU and Bearing Plastic.
Fig 2
Fig 1
Fig 3
Fig 4
Fig 5
DMB-1812LH (12K)
Fig 6
Fig 7