Dacor RNHP36 Renaissance, Руководство по установке

Страница: 13 / 33

11
Preparation and Setup
Preparing the Mounting Location
Holding brackets and hardware are provided to temporarily
hold the hood in place while you permanently fasten the
hood to the wall.
The illustrations below show the purpose of the holding
brackets and the support behind the wall.
1. If mounting the hood to brick or masonry, select
anchors capable of holding the full weight of the hood.
2. Make sure the mounting surface is properly reinforced
to support the full weight of the unit.
• If mounting the unit to drywall or a plastered surface,
install a reinforced mounting block between the studs.
• Attach screws directly to the studs and cabinets if they
align with the mounting holes in the back and top of the
hood.
Holding
Brackets
(Enlarged for Detail)
Support Block
Model Weight
RNHP3012 51 lbs. (23 kg)
RNHP3018
RNHP3612
53 lbs. (24 kg)
RNHP3618 57 lbs. (26 kg)
RNHP4812 70 lbs. (32 kg)
RNHP4818 77 lbs. (35 kg)
Stud
Stud
Support Structures Behind the Wall
Holding Brackets
WARNING
• The electricity to the range hood should be installed
only by a licensed electrician.
• Observe all governing codes and ordinances during
site preparation and installation. Contact your local
building department for further information.
• Failure to properly anchor the hood to the wall may
result in personal injury due to the unit falling off the
wall.
• To avoid an electric shock hazard and property dam-
age, locate electric wires and water pipes and avoid
drilling or cutting in the vicinity.
• Use the temporary holding brackets only to hold the
hood in place until permanent anchoring is secured.