18
English
Installation Requirements
Electrical Requirements
•
The owner shall verify that the electrical service meets electrical requirements and that the outlet is prop-
erly installed by a licensed electrician.
•
To reduce risk of fire, electric shock, or personal injury:
–
Do not use an extension cord or adapter plug with the rangetop.
–
The rangetop must be properly grounded.
–
Do not use a damaged power plug or loose wall outlet.
–
Do not modify, remove, or otherwise defeat the plug's grounding (3rd) prong. If you have a 2- prong
outlet, or you suspect the outlet is not properly grounded, have a qualified electrician check the circuit
and outlet; install the proper outlet if needed.
–
All wiring and grounding must comply with local codes or, in their absence, the National Electrical Code,
ANSI/NFPA No. 70 – Latest Revision (US), or the Canadian Electrical Code CSA C22.1 – Latest Revisions
and local codes.
–
The wiring diagram is inside the burner box.
–
All gas models are equipped with a power cord with an equipment-grounding conductor and a ground-
ing plug.
–
All gas models in the US and Canada require a 120 V, 60-Hz, AC, approved electrical service with 20-amp
circuit breaker or time-delay fuse.
–
NEVER connect ground wire to plastic plumbing lines, gas lines, or water pipes.
Failure to follow these instructions can cause fire, electrical shock, death.
Additional installation requirements for mobile homes:
Installation of appliances designed for mobile-home use must comply with the Manufactured Home Construc-
tion and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile-Home Construc-
tion and Safety, Title 24, HUD, Part 280) or, when the standard does not apply, the Standard for Manufac-
tured-Home Installations, latest edition (Manufactured-Home Sites, Communities and Setups), ANSI A225.1,
latest edition, or with local codes. In Canada, mobile-home installation must comply with the current CAN/CSA
Z240/MH Mobile-Home Installation Code.
Re-ignition may malfunction if the voltage between Neutral and Ground is over 20 VAC. Make sure the voltage
is under 20 VAC.
