Dacor Distinctive DTHP30, Руководство по установке

Страница: 13 / 32

11
Preparation and Setup
Preparing the Mounting Location
Holding brackets and hardware are provided to temporarily
hold the hood in place while you permanently fasten the
hood to the wall.
The illustrations below show the purpose of the holding
brackets and the support behind the wall.
1. If mounting the hood to brick or masonry, select
anchors capable of holding the full weight of the hood.
2. Make sure the mounting surface is properly reinforced
to support the full weight of the unit.
• If mounting the unit to drywall or a plastered surface,
install a reinforced mounting block between the studs.
• Attach screws directly to the studs and cabinets if they
align with the mounting holes in the back and top of the
hood.
Support Block
Model Weight
DTHP3010 51 lbs. (23 kg)
DTHP3018
DTHP3610
53 lbs. (24 kg)
DTHP3618 57 lbs. (26 kg)
DTHP4810 70 lbs. (32 kg)
DTHP4818 77 lbs. (35 kg)
Stud
Stud
Support Structures Behind the Wall
WARNING
• The electricity to the range hood should be installed
only by a licensed electrician.
• Observe all governing codes and ordinances during
site preparation and installation. Contact your local
building department for further information.
• Failure to properly anchor the hood to the wall may
result in personal injury due to the unit falling off the
wall.
• To avoid an electric shock hazard and property dam-
age, locate electric wires and water pipes and avoid
drilling or cutting in the vicinity.
• Use the temporary holding brackets only to hold the
hood in place until permanent anchoring is secured.
Holding
Brackets
(Enlarged for Detail)
Holding Brackets