Dacia 1304 2004, Руководство по ремонту

Страница: 359 / 654

STEERING ASSEMBLY
36
PUSHER ADJUSTMENT
SETTING OF THE ADJUSTMENT WASHERS THICKNESS
The thickness of the adjustment washers shall be measured for the lowest point of the
rack, so that a pre compression of the washer is obtained:
E = ( D + 0,06 mm ) - H
E
-
washers thickness;
D - the distance above the pusher;
H - the free height of the elastic washer;
0,06 -
pre compression of the washer.
In order to obtain an adequate thickness
which may be obtained from the existing
washers, diminish the calculated value by
0,04 mm .
On remounting, place the elastic washer (
2
) in contact with the pusher (
5
) and the
adjustment washers (
4
), in contact with the cap (
1
).
Observe the mounting sense of the elastic washer.
Place the set of washers, established by measurement above the pusher.
C
H ECKING
Place the set of the washers, established by measurement, above the pusher.
Measure the distance between the pusher
and the adjustment washers; this distance
should be equal to the free height of the elastic
washer, minus
0.02-0.06mm
.
If this value is not obtained, measure again.
Dismount the comparator support.
Remove the adjustment washers.
Put special grease, containing
MoS2
, in the
seat.
Remount:
- the elastic washer;
- the adjustment washers;
- the cap.
Tighten the cap attachment screws at the
required moment.
36 - 10
vnx.su