dabotek DT1200i, Руководство по эксплуатации

Страница: 26 / 37

26
TROUBLE PROBABLE CAUSE REMEDY
F. “E10” flashing on display 1 . No arc initiated when trigger
was pulled between stud and
work piece.
2.
Unit was dry fired, e.g. the
gun with stud was not pressed
against grounded piece of
metal
3
. Trigger was pulled with gun
in the air
1 . Clean surface
2
. Read gun manual for
procedure
.
3. Read gun manual for
procedure.
G. Display has fluctuating
amperage levels
H . Display is flashing
1. Unit is self-calibrating and
will complete calibration after
2-4 studs.
1 . One of 5-temperature
zones has overheated
1. Proceed after calibration.
1 . Wait for several minutes for
welder to cool down and display
to stop flashing
I. Fan not working 1. Fan overheated 1. Allow unit to cool down for at
least 10 minutes