D-Link xStack DES-3800 Series, Руководство CLI

Страница: 122 / 326

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
117
16
Link Aggregation Commands
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameters
create link_aggregation
group_id <value 1-32> {type [lacp|static]}
delete link_aggregation
group_id <value 1-32>
config link_aggregation
group_id <value1-32> {master_port <port> | ports <portlist> state [enable
| disable]}
config link_aggregation
algorithm [mac_source | mac_destination | mac_source_dest | ip_source
| ip_destination | ip_source_dest]
show link_aggregation {group_id <value 1-32> | algorithm}
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose Used to create a link aggregation group on the Switch.
Syntax create link_aggregation group_id <value 1-32> {type[lacp |
static]}
Description This command will create a link aggregation group with a unique
identifier.
Parameters
<value>
−
Specifies the group ID. The Switch allows up to 32 link
aggregation groups to be configured. The group number identifies
each of the groups.
type – Specify the type of link aggregation used for the group. If the
type is not specified the default type is static .
•
lacp – This designates the port group as LACP compliant.
LACP allows dynamic adjustment to the aggregated port
group. LACP compliant ports may be further configured
(see config lacp_ports). LACP compliant must be connected
to LACP compliant devices.
•
static – This designates the aggregated port group as static.
Static port groups can not be changed as easily as LACP
compliant port groups since both linked devices must be
manually configured if the configuration of the trunked group
is changed. If static link aggregation is used, be sure that
both ends of the connection are properly configured and
that all ports have the same speed/duplex settings.
Restrictions Only administrator-level users can issue this command.
Example usage: