132
Configuring Your Camera for External Trigger Based Recording
(continued)
I/O Connector (continued)
Next, click the
Applications
button under the
Tools
tab to
set the application settings for
the
DCS-2100+
.
In this window, follow the steps below to set the application settings for
snapshots to be sent to your email account or FTP server when triggered by a
motion sensor or other external device:
Select the weekdays you would like to record and enter the
“Snapshots begin” time and “Snapshots end” time for the weekly
schedule, or select “All the time except for the above schedule” if you
want to enable full time snapshot recording.
Check “Event operation.”
Set the delay “before detecting next event” to avoid continuous false
alarms following the original event.
Set the delay to “take snapshots after event” to capture the direction
of the moving object.
5
5
5
5
5
Check the trigger condition for input and motion detection (in this
case “Input is Low”).
6
6
6
6
6
Check “Trigger output alarm while input condition matched” and
“Upload snapshots while motion detected.”
7
7
7
7
7
Select to either send snapshots by email or by FTP.
Click the apply button when finished. You are now able to send snapshots,
based on triggered recording, to your e-mail account or FTP server.
Click
Applications
X
X
X
X
X
X
X
Содержание SECURICAM Network DCS-2100+
Страница 25: ...25 The installation is complete Click Finish Installing IP surveillance Software continued Click Next ...
Страница 138: ...138 Time Zone Table GMT stands for Greenwich Mean Time which is the global time that all time zones are measured from ...
Страница 139: ...139 Time Zone Table continued ...
Страница 143: ...143 Register online your D Link product at http support dlink com register 10 04 04 Registration ...