43
D-Link DWR-953 User Manual
Section 3 - Configuration
Select whether the local SNMP administration should be
Enabled
or
Disabled
.
Select whether the local SNMP administration should be
Enabled
or
Disabled
.
Enter the password public in this field to allow read-only access
to network administration using SNMP. You can view the network,
but no configuration is possible with this setting.
Enter the password private in this field to enable read/write access
to the network using SNMP.
Enter up to 4 IP addresses to use as trap targets for your network.
Select the SNMP version of your system.
If you want to limit remote access SNMP access, enter the IP
address of the remote computer you will use to access this device;
all other IP addresses will be denied remote SNMP access.
SNMP Local:
SNMP Remote:
Get Community:
Set Community:
IP 1 ~ 4:
SNMP Version:
WAN Access IP
Address:
SNMP
SNMP (Simple Network Management Protocol) is a widely used network monitoring and control protocol that reports activity on each network
device to the administrator of the network. SNMP can be used to monitor traffic and statistics of the DWR-953. The DWR-953 supports SNMP v1
or v2c.
