DIR-620S
Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
WPS
On the
Wi-Fi / WPS
page, you can enable the function for configuration of the WLAN and select a
method for connection to the WLAN.
The WPS function helps to configure the protected wireless network automatically. Devices
connecting to the wireless network via the WPS function must support the WPS function.
!
The WPS function allows adding devices only to the basic wireless network of the router.
!
Before using the function you need to configure one of the following authentication types:
Open
with no encryption,
WPA2-PSK
or
WPA-PSK/WPA2-PSK mixed
with the
AES
encryption method. When other security settings are specified, controls of the
WPS
page are not available.
Figure 104. The page for configuring the WPS function.
You can activate the WPS function via the web-based interface or the hardware
WPS
button on the
cover of the device.
To activate the WPS function via the hardware button, move the
Enable Wi-Fi when WPS
function is activated with hardware button
switch to the right. Then, with the device turned
on, push the
WPS
button and release. The
WPS
LED should start blinking. In addition, upon
pressing the button, the wireless interface of the device is enabled if it was disabled before.
If you want to disable activating the WPS function via the hardware button, move the
Enable
Wi-Fi when WPS function is activated with hardware button
switch to the left and make
sure that the WPS function is not activated via the web-based interface.
To activate the WPS function via the web-based interface, click the
ENABLE
WPS
button.
When the WPS function is enabled, the
Information
section is available on the page.
Page
127
of 236
