D-Link DGS-3200-16 - Switch - Stackable, Руководство пользователя

Страница: 21 / 273

xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
8
Setting the Switch’s IP Address using the Console Interface
Each Switch must be assigned its own IP Address, which is used for communication with an SNMP network manager or other
TCP/IP application (for example BOOTP, TFTP). The Switch’s default IP address is 10.90.90.90. The default Switch IP address
can be changed to meet the specification of your networking address scheme.
The IP address for the Switch must be set before the Web-based manager can manage the switch. The Switch IP address can be
automatically set using BOOTP or DHCP protocols, in which case the actual address assigned to the Switch must be known. The
IP address may be set using the Command Line Interface (CLI) over the console serial port as follows:
•
Starting at the command line prompt, enter the commands
config ipif System ipaddress xxx.xxx.xxx.xxx/
yyy.yyy.yyy.yyy.
Where the x’s represent the IP address to be assigned to the IP interface named System and the y’s
represent the corresponding subnet mask.
•
Alternatively, the user can enter
config ipif System ipaddress xxx.xxx.xxx.xxx/z.
Where the x’s represent the IP
address to be assigned to the IP interface named
System
and the z represents the corresponding number of subnets in
CIDR notation.
The IP interface named System on the Switch can be assigned an IP address and subnet mask, which can then be used to connect a
management station to the Switch’s Telnet or Web-based management agent.
Successful entry of the command will produce a “
Success”
message
,
indicating that the command execution was correctly. The
user may now utilize this address to configure or manage the Switch through Telnet, the Command Line Interface (CLI) or the
Web-based management (GUI).
IPv6 Interface Settings
Users can display the Switch’s current IPv6 interface settings.
To view the following window, click
Configuration
>
IPv6 Interfaces Settings
:
Figure 2- 5. IPv6 Interface Settings window
To configure IPv6 interface settings, enter an Interface Name, a VLAN Name, and make sure the Interface Admin. State is
Enabled . Click the
Create
button. The new entry will appear in the Interface Table at the bottom of the window.
To modify an Interface Table entry, click the corresponding
Edit
button. The following window opens:
Figure 2- 6. IPv6 Interface Settings (Edit) window
After making the desired changes, click the
Apply
button.