Intended use
- Louvre drive for infinitely electric opening and
®
closing of Hahn louvre windows of type S9, S9-45°,
S9iV, S9iVt-05, S9iVt-05 All-glass and Tairmo
- The louvre must be prepared by the louvre
manufacturer for the application of the drive
- Operating voltage 230 V AC
- Usable for smoke extraction as well as daily
ventilation
- Only for inside mounting
Performance Features
Safety notes
- Microprocessor controlled synchro electronics for
a precise synchronous run of up to 4 drives
- Individually programmable (via SCS software)
- Protection system for the main closing edge
Electrical devices, accessories and packaging
should be sorted for environmental-friendly recycling.
Do not dispose electrical devices into household
waste!
Only for EC countries:
According the European Guideline 2012/19/EU for
waste electrical and electronic equipment and its
implementation into national right,
electrcal devices that are no longer
usable must be collected separately
and disposed of in an environmentally
correct manner.
Disposal
Declaration of Conformity
We declare under our sole responsibility that the
product described under “Technical Data” is in
conformity with the following directives:
2014/30/EU, 2014/35/EU
Technical file at:
D+H Mechatronic AG, D-22949 Ammersbek
Thomas Kern
Maik Schmees
Member of the Board
Authorized signatory, Technical Director
26.03.2015
LAH 65-K-BSY+
LAH 65-K-BSY+
99.826.57 1.0/07/15
99.826.57 1.0/07/15
6/20
7/20
English
English
Technical Data
Type
LAH 65-K-BSY+
Power supply
230 V AC / ±10% / 50 Hz
Power consumption
22 W / 35 VA
Torque *
0,3 Nm ... 4,5 Nm (corresponds 0,6 Nm ... 9 Nm on the output side)
Running speed *
3,5°/sec. ... 10,9°/sec.
Opening angle *
85 °
Lifetime
>10 000 double strokes
Duty cycle
50 %, With cycle time 10 minutes
Housing
die-cast zinc
Ingress protection
IP 54
Temperature range
-5 ... +75 °C
Fire stability
30 min / 300 °C
Dimensions W x H x D
260 x 71 x 37 mm
Additional functions *
Closing edge protection activated, 3 stroke repeatings
* Programmable with SCS software
Running speed
s
e
g
n
a
R
e
r
u
s
o
l
C
~9°/sec.**
CLOSED
OPEN
8°**
25°**
4°/sec.**
4°/sec.**
9°/sec.**
** factory parameter
Guarantee
You will get
2 years guarantee
for all D+H products
from date of verified handing over of the system up to
maximal 3 years after date of delivery, when
mounting and starting has been carried out by
an
authorized D+H-distributor.
D+H guarantee is expired, with connection of D+H
components with external systems or with mixing of
D+H products with parts of other manufacturers.
Maintenance and cleaning
Inspection and maintenance has to be carried out
according to D+H maintenance notes. Only original
D+H spare parts may be used. Repair is to be carried
out exclusively by D+H.
Wipe away debris or contamination with a dry, soft
cloth.
Do not use cleaning agents or solvents.
Closing edge protection
In the "CLOSE" direction the drive has an
active protection for the main closing
edge. If there is an overload in the closing
range 3 and 2, the drive runs "OPEN" for
10 seconds, then "CLOSE" again. If after
three attempts closing is not possible, the
drive remains in this position.
In addition, the drive is equipped with
passive protection. The closing speed in
closing range 2 and 1 is reduced.
Significantly greater forces
can be exerted at the
secondary closing edges.
Danger of crushing hands
and fingers!
A synchron-group (LAH 65-K-BSY+) can be count up
to 4 drives, which communicate by a bus. Each drive
has it’s own adress. This adress is configurable with
SCS software.
The last drive of a synchron-group is the master,
which controls the other drives, the slaves. Different
forces between the drives of a group will balanced
with intelligent force- and position control. In case of
malfunction respective cutoff of a drive, all drives will
shut down from the master-drive.
Functional description
Operating voltage 230 V AC!
Risk of injury from electric shock!
Do not reverse L+N! Connect PE!
Before mounting / demounting completely
disconnected and volt-free!
- Connection has to be carried out only by an
authorized electrical specialist
- Danger of violent pressure in handaccessible area
- Keep away People from the operating area of the
drive
- Keep away children from the control
- Use only in dry rooms
- Only for inside mounting.
Use rain detector with danger of rain
- Just use unchanged original D+H parts
Observe enclosed r
ed safety slip!
