3. Install latch.
Insert latch in door. (Be sure bevel
edge of bolt faces strike plate.)
Attach with two screws supplied.
2. Drill door.
C. Drill two (2) 5/16" (8mm) dia.
A. Drill 2-1/8" (54mm) dia. hole thru
holes thru door. See note.
the door. Cut notches as shown on
template. See note. (Except
D. Drill pilot holes for latch
Dummy Trim)
screws. 7/64" (2.5mm) dia.
(Except Dummy Trim)
B. Drill 1" (26mm) dia. hole in edge of
door. Mortise for latch front 1-1/8"
Note:
To avoid splintering wood
(29mm) wide x 2-1/4" (57mm) high
doors, drill holes (A) and (C) from both
x 5/32" (4mm) deep. (Except
sides of the door.
Dummy Trim)
D
B
1. Mark door.
Mark horizontal line across edge of door.
For beveled and square edge doors,
40-5/16" (102cm) is the usual height
mark both sides of the door.
above the floor. Fold template over edge
of door, centering on horizontal line.
Note:
Mark centers of holes at proper backset.
Be sure to verify backset before
marking & drilling door.
5400LN Series
Cylindrical Lever Lockset
Installation Instructions
Grade 1
Attention Installer
Installation of cylindrical locks and latches must be through
bolted in all doors. If installation instructions are not followed this
may result in damage to the lock and void the factory warranty.
Any retrofit or other field modification to a fire rated opening can
potentially impact the fire rating of the opening, and Yale Locks &
Hardware makes no representations or warranties concerning
what such impact may be in any specific situation. When
retrofitting any portion of an existing fire rated opening, or
specifying and installing a new fire-rated opening, please consult
with a code specialist or local code official (Authority Having
Jurisdiction) to ensure compliance with all applicable codes and
ratings.
Tools Required
• 2-1/8" (54mm) hole saw
• 1" (26mm) boring bit
• 5/16" (8mm) drill bit
• 7/64" (2.5mm) drill bit
• chisel & hammer
• #2 phillips screw driver
• handle removal tool (supplied)
• 3/8" or 1/2" drill
IMPORTANT:
The accuracy of the door preparation is
critical for the proper functioning and security of this lever
handle lock. Misalignment can cause premature wear and
tear and a lessening of security.
Door
Marker
4. Unpack lock.
Through Bolts
Inside Rose
Support Assembly
Outside Assembly
(stays assembled)
Inside Lever
Handle
Rose Scalp
An ASSA ABLOY Group brand
80-9150-0056-010 (01-13)