3
11
3. Operation
3.1. Check or adjust before each ride
1/ All fastening components, make sure they are OK, fastened or tightened and show no signs of damage.
2/ Position and function of the brake levers. Make sure you know where and on which side the front and rear brakes are located.
3/ Tires pressure.
4/ With the engine off, if the gas returns to its starting position after adding gas.
5/ Condition of gears and chain lubrication.
6/ All electrical components on the machine, all cables and components must be in perfect condition and in the correct position.
7/ Charging the battery.
After any fall it is always necessary to completely revise the condition of the vehicle. To be completely sure visit any Drill dealer.
3.2. Battery and charger, electrical components
3.2.1. Basic instructions
The battery is provided with a safety seal, the battery can only be opened by a Drill dealer. If this seal is damaged, you will lose your warranty.
Fully charge the battery before the first use. The battery is equipped with BMS, which constantly evaluates the current status of the battery and
optimizes its performance. If the battery charge falls below 25% while driving, the control unit automatically reduces engine power. The system
is deactivated before the battery is completely discharged. Battery life may vary depending on the conditions in which the machine drives and
the riding style.
