Czaki EMT-200, Руководство по эксплуатации

Страница: 9 / 24

After making changes confirm them by depressing „
tu
” („ TAL ”
message will start blinking again).
Depressing „ u ” we can reach the next position of menu.
Depressing „
p
” we leave „ TAL ”, pressing again „
p
” we go out of
the programming mode and enter the temperature measurement mode.
4.2. Setting alarm thresholds
Using „ u ” select position „ P1 ” or „ P2 ” in the alarm programming mode.
The auxiliary display will show the current value of the alarm
threshold temperature. To change its value depress „
tu
”, (the first
digit of the auxiliary display will start blinking).
Using „
p
” set the required value, then using „
u
” go to the next digit.
A parameter can assume values from 100 to +1800 .
After making changes confirm them by „ tu ” ( „ P1 ” or „ P2 ” will start
blinking again).
Depressing „ p ” we come out of „ P1 ” or „ P2 ”, depressing again „ p ”
we leave the programming mode and enter the temperature
measurement mode.
ATTENTION : Take care to set the value of the first threshold
(„ P1 ”) below the value of the second threshold („ P2 ”).
Otherwise alarms may function improperly.
5. MEMO menu
The meter is equipped with the RS232 serial port. It enables easy
connection between the meter and the computer for bi-directional data
transmission, or between the meter and the printer for creating a simple
temperature recorder.
The serial port makes possible:
- Non-recurrent or periodical readout of measured temperature
- Alarm parameter readout,
- Alarm parameters recording,
- Adjustment of data transmission rate
9