Czaki EMT-200, Руководство по эксплуатации

Страница: 13 / 24

Using „
u
” select „ RESE ” position.
The auxiliary display will show the current parameter value. To
change it depress „
tu
” (the digit in the auxiliary display will start
blinking).
Using „
p
” set the required value.
The parameter can assume the following values:
!
0 function off,
!
1 depressing „
tu
” will restore factory settings.
Confirm completed changes by depressing „
tu
” (factory settings
will be entered to the meter memory)).
Depressing „ p ” we come out of „ SYST ”.
Switch off the meter.
7. TEPR menu
7.1. Sensor type
Selection of the type of sensor connected to the meter.
Switch on the meter depressing „ p ” at the same time.
Enter the programming mode by depressing „ p ” for approx. 3
seconds. Select from menu the „ TEPR ” position using „ u ”, confirm by
„
tu
”.
Using „
u
” select „ SNSR ” position.
The auxiliary display will show the sensor symbol. To change it
depress „
tu
” (the sensor symbol in the auxiliary display will start
blinking).
Using „ u ” set the required sensor type.
The parameter can assume the following values (corresponding
symbols that will be displayed are shown in square brackets):
!
thermocouples T [ ], J [ ], K [ ], R [ ], S [ ], B [ ], N [ ]
!
thermistors Pt100 [ ], Ni100 [ ]
Confirm completed changes by depressing „
tu
” („ SNSR ” will start
blinking again).
Depressing „
p
” we come out of „ SNSR ”.
Switch off the meter.
13