Czaki EMT-200, Руководство по эксплуатации

Страница: 6 / 24

3.Programming mode
The programming mode is entered by pressing „
p
” for approx. 3
seconds.
It results in the message „ AL_1 ” appearing on the main display.
Repetitive depressing of „
u
” scrolls consecutive menu positions.
Finding the appropriate menu position is confirmed by pressing
„
tu
”.
Depressing „
p
” causes entering the higher menu level. The same at
the highest menu level results in leaving the programming mode and
entering the temperature measurement mode.
If the user does not change any parameters the programming mode
will go off automatically after approx. 90 seconds.
At the parameter change procedure the key „
p
” changes the value
under the cursor, and the key „ u ” shifts the cursor position (if possible).
6
Changing parametr value:
Using „ u ” activate the digit to be changed on the auxiliary display ;
Using „ p ” set the new value;
Repeat this procedure till the required value is set completely;
Introduced changes confirm by „
tu ”. It causes memorizing the
parameter value.
ATTENTION : If the entered value exceeds premissible limits then on
the auxiliary display the „ ERR ” message appears for a while, after that
the previous value (before modification) is continously displayed.