Czaki EMT-200, Руководство по эксплуатации

Страница: 10 / 24

The keyboard makes possible triggering the cyclic temperature
readout through the port (this option is used for the meter - printer
arrangement), and setting the meter address.
The parameter programming mode is entered by selecting the
„ MEMO ” position from menu, and confirming it by „
tu
”.
5.1. Cyclic readout period
Determining the period between the consecutive recordings of data,
or consecutive data transmissions to the RS232 port.
In the programming mode „ MEMO ” select the position „ RSCT ” by „
u ”. The auxiliary display indicates the current value in seconds. To
change it depress „
tu
” (the digit on the auxiliary display will start
blinking). Using „
p
” set the required value.
The parameter can assume values from 1 to 240 .
Changes should be confirmed by „
tu
” (the message „ RSCT ” would
start blinking again).
Depressing „ u ” we can reach the next position of menu.
Depressing „ p ” we come out of „ RSCT ”, depressing „ p ” again we
leave the programming mode and enter temperature measurement
mode.
5.2. Printing results
Determining whether measurement results should be sent to the
RS232 port.
Using „ u ”select the position „ TPRI ” in the programming mode
„ MEMO ”.
The auxiliary display indicates the current value of the parameter. To
change it depress „ tu ” (the digit on the auxiliary display will start
blinking).
Using „
p
” set the required value.
The parameter can assume the following values:
!
0 results are not sent to the RS232 port,
!
1 sends measured temperature with frequency determined by
„ RSCT ” (see item. 5.1 ).
!
2 sends measurement data from the memory (this operation does
not erase the results).
10