Czaki EMT-200, Руководство по эксплуатации

Страница: 15 / 24

8. R232 menu
These parameters make possible adequate configuration of the
RS232 port for co-operation between the meter and a computer or a
printer. Data transmitted between the computer and the meter are in
ASCII code. They consist of 8 data bits and one stop bit.
Switch on the meter depressing „
p
” at the same time.
Enter the programming mode by depressing „
p
” for approx. 3
seconds. Select from menu the „ R232 ” position using „
u
”, confirm by
„
tu
”.
8.1. Meter address
A meter address is intended for selecting data directed to a particular
meter by the co-operating computer. Different address values are required
in case few meters are connected to one computer (it concerns meters
equipped with the RS485 interface).
Using „ u ” select „ ADR in the programming mode „ R232 ”” .
The current value of the parameter will be presented on the auxiliary
display. To change this value depress „
tu
” (the first digit of the auxiliary
display will start blinking). Using „
p
” set the required value, depressing
„
u
” go to the next digit.
The parameter can assume values from 1 to 99 .
Completed changes should be confirmed by „ tu ” („ ADR ”) message
would start blinking again).
Depressing „ p ” we leave „ ADR ”.
Switch off the meter.
8.2. Transmission rate
Using „
u
” key select the position„ BAUD ” In the programming mode
„ R232 ”.
The current value of the parameter will be presented on the auxiliary
display. To change this value depress „
tu
” (the first digit of the auxiliary
display will start blinking). Using „
u
” set the required value.
The parameter can assume the following values: 600, 1200, 2400,
4800, 9600
15