Czaki EMT-200, Руководство по эксплуатации

Страница: 14 / 24

7.2. Resolution of measurements
Determining the method of presenting results on the display.
Enter the programming mode by depressing „
p
” for approx. for 3
seconds. Select from menu the „ TEPR ” position using „ u ”, confirm by
„
tu
”.
Using „ u ” select „ TPOI ” position.
The auxiliary display will show the current parameter value. To change
it depress „ ” (the digit in the auxiliary display will start blinking).
Using „ p ” set the required value.
The parameter can assume the following values:
!
0 results displayed in 0.1°C resolution,
!
1 results rounded to full degrees.
Completed changes should be confirmed „
tu
” („ TPOI” would start
blinking again).
Depressing „
p
” we leave z „ TPOI ”, depressing „
p
” again we come out
of the programming mode and enter the temperature measurement mode.
7.3. Characteristic offset
This parameter makes possible compensating resistance of cables
connecting the meter and the thermistor, or to offset the thermocouple
characteristic in case lower grade thermocouple sensor is used. Appropriate
(different from zero) offset should be introduced to compensate a constant
difference between the actual temperature of the sensor and the temperature
indicated by the meter.
Switch on the meter depressing „ p ” at the same time.
Enter the programming mode by depressing „
p
” for approx. 3
seconds. Using „ u ”select the „ TOFF ” position from menu.
The auxiliary display will show the current value of the parameter. To
change it depress „
tu
” (the first digit of the auxiliary display will start
blinking).
Using „
p
” set the required value, then depressing „
u
” go to the next
digit.
The parameter can assume values from 9.9 to +9.9 .
Completed changes should be confirmed by „
tu
” („ TOFF ” message
would start blinking again).
Depressing „
p
” we leave „ TOFF ”.
Switch off the meter.
14