Cypress EZ-PD CY4502, Руководство пользователя

Страница: 27 / 38

Kit Operation
CY4502 EZ-
PD™ CCG2 Development Kit Guide, Doc. No. 001-96601 Rev. *B
27
Jumper Position Comments
J40 Closed Enabling VCONN connectivity. Power measurement
jumper at VCONN.
J44 Closed Enabling supply to CCG1. Power measurement jumper.
Note: Other jumpers on CCG1 Host Demo board, not listed in Table 3-5, can be retained in any position for this.
For more details on the CCG1 Host Demo board, refer CCG1 Demo Kit page.
2. Open PSoC Programmer.
3. Connect one end of the USB Mini-B cable to the Mini-USB connector J11 on the CCG1 Host Demo board and
connect the other end to the PC.
Note: If a warning message window pops up asking to upgrade the firmware, Click OK to close the window. Upon
closing the window, Click the Utilities tab and then click the Upgrade Firmware button. On successful upgrade,
the Action and Results window displays the firmware update message with the KitProg version.
4. Select the KitProg device from the Port Selection window, as shown in Figure 3-17 .
5. The status message in the right bottom of the PSoC Programmer will indicate that the board is powered.
6. Click the File Load button and point to the dfp_fw_ver2.hex file to load it. Contact Cypress to get the firmware file,
dfp_fw_ver2.hex .
7. Use the Program button to program the hex file onto the chip.
8. When the file is successfully pr
ogrammed, “Programming Succeeded” appears in the
Actions window.
Figure 3-17. PSoC Programmer Window
9. After successful programming of CCG1 Hose Demo board, go to Step 2 of section 3.7.2
File Load
b
Program