CYP IP-A750RX, Руководство по эксплуатации

Страница: 19 / 32

14
6.5 Telnet Control
Before attempting to use Telnet control, please ensure that both the unit
and the PC are connected to the same active networks.
Start your preferred Telnet/Console client, or use the built in client
provided by most modern computer operating systems. After starting
the client, connect by using the current IP address of the unit and port
23 (if the communication port number used by the unit has not been
changed previously). This will connect us to the unit we wish to control
and commands may now be entered directly.
Note 1: If the IP address of the unit is changed then the IP address required for
Telnet access will also change accordingly.
Note 2: This unit defaults to Auto IP mode. The current IP address can be
verified using the Device Discovery software. The default communication port
is 23.
6.6 Serial and Telnet Commands
COMMAND
Description and Parameters
help

Show the full command list.
help N1

Show details about the specified command.
N1 = {Command}
get fw ver

Show the unit’s current firmware version.
get hw ver
Show the unit’s current hardware version
get command ver

Show the unit’s current command version.
get mac addr

Show the unit’s MAC address.