CYP IP-A750RX, Руководство по эксплуатации

Страница: 25 / 32

20
COMMAND
Description and Parameters
get showme

Show the current state of the showme function.
set stream cast mode N1

Set the AoIP transmitter’s network broadcast mode.
Available values for
N1:
UNICAST [Unicast mode]
MULTICAST [Multicast mode]
get stream cast mode

Show the AoIP transmitter’s current network broadcast mode.
set tx 1 audio in 1 route rx N1 A

Route the specified transmitter’s current audio input to this receiver’s
audio outputs.
N1 = 0~255
[Channel index value]
get tx 1 audio in 1 route rx

Show the channel index number of the transmitter whose audio is
currently routed to this receiver.
set tx 1 uart route rx N1

Route the specified transmitter’s RS-232 input to this receiver’s RS-
232 output.
N1 = 0~255
[Channel index value]
g et tx 1 uart route rx

Show the channel index number of the transmitter whose RS-232 is
currently routed to this receiver.
Note: Commands will not be executed unless followed by a carriage return.
Commands are not case-sensitive.