CYP CH-U330RX, Руководство по эксплуатации, Страница: 14 / 28

9
6.5 IR Cable Pin Assignment
3
2
1
IR Blaster
Power
IR Signal
NC
6.6 WebGUI Control
Connect both the Transmitter and Receiver to active gigabit networks
through Cat.5e/6 and verify that both units are set to the same LINK
PAIR ID and that both LINK LEDs are lit solidly. If the LINK LEDs are
blinking, please re-check the network connections and try again.
On the Receiver side, connect a display to the HDMI output port and
the screen will display the TCP/IP information for both the Receiver
(Local IP) and the Transmitter (Remote IP). The current firmware version
will also be displayed. See below for reference.
Use these IP addresses to connect to the WebGUI for either the
Receiver or Transmitter in a web browser. This will allow for the viewing
or control of each unit’s configuration and information.
The WebGUI is divided into 3 tabbed sections: System, Network and
Functions.