CYP CH-U330RX, Руководство по эксплуатации, Страница: 12 / 28

7
PAIR ID.
7 VIDEO LINK: The video link with the Receiver can be enabled
or disabled with this button. When the link is disabled and the
Receiver is connected to a monitor it will display the system’s
current IP and firmware information.
Shortcut Key Function:
Reset to default (auto IP & multicast) mode: Press and hold this
button when powering the unit on until both the POWER and LINK
lights are blinking. Once both lights are blinking you can power
the unit off and back on and it will be in the default auto IP and
multicast modes. The IP address will be assigned automatically
within the 169.254.xxx.xxx address range.
8
VIDEO MODE: Selects the video mode for streaming data between
“Graphic” and “Video” modes. “Graphic” mode is optimized for
high-detail static displays and “Video” mode is optimized for full
motion video.
Shortcut Key Function:
Anti-Dither Mode (Certain ATI Graphic Cards): Press and hold this
button for 3 seconds to enable and switch between the three
“Anti-Dither” modes (1-bit, 2-bit and off). Certain graphics cards
use dithering to emulate a larger color palette, but dithering
causes difficulty for maintaining low-bandwidth during real-time
video compression, so these Anti-Dithering modes are designed to
remove the dithering prior to compression and transmission of the
signal. If the source is not using dithering, please leave this feature
disabled as it may cause a blocking effect with non-dithered
content. This feature is disabled by default.
9
USB 1.1/2.0: The 2 USB 1.1 slots provide connections for slower USB
devices such as keyboards, mice, etc. The 2 USB 2.0 slots provide
connections for USB devices requiring higher transfer speeds such
as thumb drives.
Note: Isochronous (steady streaming) data devices such as USB
cameras and external hard drives are not supported.