CYP CH-U330RX, Руководство по эксплуатации, Страница: 11 / 28

6
6.3 Receiver's Front Panel
ON
1 2 3 4
RS232 LINK PAIR
SEL
IR IR
BLASTER
POWER
LINK USB 1.1 USB 2.0
MODE LINK
VIDEO
4K UHD Video over IP Rx
3 1 2 4 5 6 7 8 9
1
POWER LED: This LED will flash BLUE while the unit is powering on and
will illuminate solid BLUE once it is ready to be used.
2 LINK LED: If the Receiver has no network connection the LINK LED
will not illuminate. While the Receiver is attempting to establish
a connection with a Transmitter the LINK LED will flash ORANGE.
When the Receiver has established a stable connection with a
Transmitter the LINK LED will illuminate in solid ORANGE.
3
RS232: Connect directly to an RS-232 controllable device to
receive commands from the device connected to the Transmitter.
The baud rate is configurable, but the default baud rate is 115200.
When the Transmitter is in multicast mode every connected
Receiver unit can send RS-232 commands to the Transmitter
and commands sent from the Transmitter side will be sent to all
connected Receivers.
4
IR BLASTER: Connect to the provided IR Blaster to transmit IR signals
from the Transmitter to devices within direct line-of-sight of the IR
Blaster.
5 IR WINDOW: Accepts IR signals from any standard remote control
and sends the signal to the associated Transmitter.
6
LINK PAIR SEL: These 4 dip switches determine the unit’s LINK PAIR
ID (0-15). Please check the chart at the end of this manual for the
dipswitch combination values. In unicast mode the LINK PAIR ID of
the Transmitter must be set to the same value as the destination
Receiver. In multicast mode all destination Receivers must be
set to the same ID as the multicast Transmitter. In both cases, all
Transmitters and Receivers must be connected to the same local
subnet. Up to 16 Transmitter/Receiver pairs can exist within the
same network, depending on available network bandwidth and
the resolution of each video stream. The factory default setting
for each unit is “0”. Please reboot the unit after changing the LINK