CynkoMet DZIK N-200, Инструкция по использованию и эксплуатации

Страница: 39 / 51

Cynko Met N-200
Page 39
are found on bearing mounts.
NOTE!
NOTE!
It is essential, before each use to check the status of the
tightening of the adapter’s blades. Failure to observe this activity
can lead to severe damage to the machine or persons located in
the proximal and distal distance from the working machine.
4.2 Conveyor feed adjustment.
Adjusting conveyor feed involves setting lever (1) from angled position to
vertical position. This is done by pushing the lever upwards and removing the
pin from its groove, then inserting it into another groove and releasing the
lever so that the pin slides freely into the recess. This control causes coupling
or decoupling of the cam-ratchet mechanism with the driving wheel’s drive.
In addition, conveyor feed can be changed using the lever found on the rear
of the mini-spreader.
Figure 10. Conveyor feed control lever in off position
4.3 Adapter drive control.
Adapter drive control involves setting the lever from angled position to
vertical position. This is done by pushing the lever upwards and removing the