CyClone DV160, Инструкция по установке и эксплуатации, Страница: 9 / 30

9 DV160 Installation - English
10 mm (3/8")
slope 3˚
Ø130 mm (5 1/8")
slope 3˚
60 mm (2 3/8")
2 holes
Ø 8 mm (5/16’’)
2 holes
2. Use a master plate to mark two Ø 130 mm (5 1/8”) holes for the air ducts and two Ø 8 mm (5/16”) holes for the dowels.
3. Remove the master plate and drill through holes for the air ducts and the 60 mm (2 3/8”) deep holes for the dowels. Drill the holes for the air ducts sloped
down by 2-3°. Then insert the dowels (included into delivery set) into respective holes.
4. Re-install the master plate with a sealing tape back. Fix the master plate
from the MK1 DV160 or MK2 DV160 mounting kit on outer wall side to align the
air ducts with respect to each other. Fix the master plate from the mounting kit
somewhat lower to ensure the minimum required slope 3°. Before mounting the
master plate press the perforated holes to remove the master plate fragments
and prepare holes for the air ducts.
5. Insert the air ducts inside the holes in the master plate designed for the air
ducts and seal those with a mounting foam through the holes in the master plate.
Install the air ducts sloped down by 2-3° to ensure the condensate drainage
from the unit.
6. After the mounting foam gets hard (see the solidification time in the product
specification) remove the master plate and cut off the protruding parts of the
air ducts to be flush with the inner wall. On outer wall side, the air ducts must
protrude for 10 mm (3/8’’) to prevent condensate dropping on the wall.
7. Unit installation sequence:
•
Open the front panel and remove the heat exchanger.
•
Connect the unit spigots to the plastic air ducts.
•
Fix the unit to the wall with the screws 5,0x50 from the delivery set by inserting those to the Ø8 mm (5/16”) holes.
•
Install the heat exchanger and close the front panel.
•
Install the NB DV160 outer ventilation hood on outer side of the building to prevent ingress of large foreign objects into the air ducts
Attention! The round plastic air ducts and the outer ventilation hood are not included into the delivery set and are available on separate order.
You may use other ventilation grilles and hoods of the matching size.