CyClone DV160, Инструкция по установке и эксплуатации, Страница: 3 / 30

3 DV160 Installation - English
IMPORTANT SAFETY INSTRUCTIONS
UNIT MOUNTING SAFETY PRECAUTIONS
The unit must be disconnected from the
power supply prior to every installation or
repair operation.
The unit must be grounded!
The unit must not be operated outside the
temperature range stated in the user’s
manual or in aggressive or explosive
environments.
While installing the unit follow the safety
regulations specific to the use of electric
tools.
Do not change the power cord length at your
own discretion. Do not bend the power cord.
Avoid damaging the power cord.
Do not position any heating devices or
other equipment in close proximity to the
unit power cord.
Do not wash the unit with water. Protect the
unit electric parts from water ingress.
Use the unit only as intended by the
manufacturer. Do not connect clothes
dryers or similar equipment to the unit or
the ventilation system!
Disconnect the unit from power supply prior
to maintenance.
Do not damage the power cable while
operating the unit. Do not put any objects
on the power cable.
Do not open the operating unit. In case of unusual sounds, smoke
disconnect the unit from power supply and
contact the service centre.
In case of long lasting operation of the unit
check the mounting reliability periodically.
Do not block the air duct when the unit is
on.
• Read the user’s manual carefully prior to the operation and installation of the single-room heat recovery unit, hereinafter the unit.
• Installation and operation of the unit shall be performed in accordance with the present user’s manual as well as the provisions of
all the applicable local and national construction, electrical and technical codes and standards.
• The warnings contained in the present user’s manual must be considered most seriously since they contain vital personal safety
information.
• Failure to follow the safety regulations may result in an injury or unit damage.
• Read the manual carefully and keep it as long as you use the unit.
• While transferring the unit control the user’s manual must be turned over to the receiving operator.
WARNING
Symbol legend used in the manual:
WARNING!
DO NOT!
OFF
ON