2410-41, 2410-42, and 2410-43 FEP Maintenance & Support Guide
3-1
Revision 1.0, May 2006
CHAPTER 3
INSTALLATION GUIDELINES
3.1
INSTALLATION GUIDELINES
The following guidelines and instructions apply to the 2410-43, 2410-42 and 2400-41.
1.This unit is for use only in a Restricited Access Location (RAL).
2.The external grounding terminals are marked with symbol
(60417-1-IEC-5019).
3.These 2 grounding terminals must be connected to earth ground.
4.Do not connect or disconnect the power connector under load
5.The DC power supply cord must be protected against physical damage.
6.Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater than room ambient. Therefore, consider-
ation should be given to installing the equipment in an environment compatible with the maximum
ambient temperature (Tma) specified by the manufacturer.
7.Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
8.Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous
condition is not achieved due to uneven mechanical loading.
9.Circuit Overloading - Consideration should be given to the connection of the equipment to the supply
circuit and the effect that overloading of the circuits might have on overcurrent protection and supply
wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this
concern.
10.Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained. Particular
attention should be given to supply connections other than direct connections to the branch circuit (e.g.
use of power strips).
