CONFIGURATION & CONNECTORS
2410-41, 2410-42 and 2410-43 FEP Maintenance & Support Guide
2-11
Revision 1.0, May 2006
2.9.1.3
Ground Studs
There are two #10-32 threaded studs (with hex nuts, flat washers and star washers included) attached to
the chassis of the FEP. Ring lugs should be used to attach chassis ground to the ground studs. Table 2-8
shows AMP/Tyco part numbers for typical ring lugs for #10 studs.
Table 2-8. Ring Lugs for #10 Studs
2.9.2
CPCI-824 Console Connector
The CPCI-824 Console Connector is a narrow RJ11 (6 positions) phone jack. The console port is an
RS232 serial port using a simple three-wire connection (transmit data, receive data & ground). The
connector assignment is as shown in Table 2-9. Normal system operation does not require a connection
to the CPCI-824 console connector.
Diagnostic or debug activity may require connecting to the CPCI-824 console connector. A cable
connecting the console port to a standard DB25 connector is available from Cyclone Microsystems (P/N
530-2006). A terminal (or PC running a terminal emulation program) should be set up for any baud up
to 115K baud, 8 bits, no parity and 1 stop bit.
Table 2-9. Console Port Connector
2.9.3
10/100Base-T Ethernet Port Connector
The Ethernet Ports Connector 10/100 Base TX is a shielded RJ45 phone jack. The pin assignments are
as shown in Table 2-10.
Wire Gauge
AMP/Tyco Part
14-16 AWG
320630
10-12 AWG
36161
Pin
Signal
Description
1
-
N/C
2
GND
Ground
3
TXD
Transmit Data
4
RXD
Receive Data
5
-
N/C
6
-
N/C
