Cyclades alterpath pm10, Инструкция по установке, администрированию и эксплуатации, Страница: 131 / 140

Circuit Breakers 111
PM10i-32A and PM10i-32Au
PM10i-32A and PM10i-32Au
The PM10i-32A has two 16-amp circuit breakers. The first circuit breaker
controls outlets 6 through 10; the second controls outlets 1 through 5. In the
event that the total current flow to outlets 6 through 10 exceeds 16 amps due
to equipment connected to these outlets, the first circuit breaker will trip
causing outlets 6 through 10 to shutdown. This does not affect outlets 1
through 5, which are controlled by the second circuit breaker.
As the PM10i-32A has the controller powered from the line side of one of the
circuit breakers, the whole unit will be inoperative only if both circuit
breakers trip, but the controller will still function.
When either circuit breaker trips, only the power outlets of that segment will
be affected, and half of the outlets remain operative.
PM20-L30A
The PM20-L30A has two 15-amp circuit breakers. The first circuit breaker
controls outlets 11 through 20; the second controls outlets 1 through 10 as
well as the power supply to the logic board. In the event that the total current
flow to outlets 11 through 20 exceeds 15 amps due to equipment connected to
these outlets, then the first circuit breaker will trip causing outlets 11 through
20 to shutdown. This does not affect outlets 1 through 10 which is controlled
by the second circuit breaker.
If, however, current overload causes the second circuit breaker to trip, then the
entire power unit shuts down because the power supply is also tied to the
second circuit breaker.