CYBEX LT-16602-4, Руководство по эксплуатации для владельца

Страница: 91 / 98

Cybex Sport Treadmill Owner’s & Service Manual
B. Disconnect the display cable (P1 and P2) from the lower board. See Figure 21.
C. Disconnect the display cable (P3 and P8) from the upper display board. See Figure 24.
D. Using a Phillips head screwdriver, loosen the wire retaining screw that holds the
display cable in place near the display board.
E. Remove the cable from the wire ties at the junction and near the bottom of the upright.
F. Using wire cutters, cut the cable at its center near the junction and pull both ends
out of the treadmill.
NOTE: Pull the upper end up and out and the lower end down
and out.
NOTE: Display cables have a revision number label so that you can verify that you have the
latest revision of the cable.
6. Attach the new display cable.
A. Locate the P1 and P2 end of the display cable.
B. Push the P2 connector down into the
top handrail hole with the P1 connector
pointing up. See Figure 28.
C. Push the display cable down through
the handrail and out the handrail’s
bottom hole. See Figure 29.
NOTE:
Twisting the cable as you push will help
it go through.
D. Push the display cable down through
the upright and out the exit hole.
NOTE: There is a black line on the
display cable to show you how far to
pull out the cable. When you see the line, stop pulling the cable out.
E. Route the cable into the access hole.
F. Connect the display cable to the lower control board at P1 and P2.
7. Secure the cable.
A. Using a Phillips head screwdriver, open the clip described in step 5D and secure the
cable in the clip.
B. Locate the line on the display cable described in step 6D and tie the cable with the
wire tie near the bottom of the upright.
C. Open the wire holder at the junction, put the cable inside and close the wire holder.
D. Check to see that all of the connectors are connected firmly in their proper place.
E. Place the lower board shield in position and push the clips down. NOTE: The clips will
snap in.
Figure 28
Large P2
Connector
Down
Small P1
Connector
Up
Service
Page 7-35