CYBEX Arc Trainer 630A, Руководство по обслуживанию

Страница: 60 / 70

Figure 4
B. Using a 7/32” Allen wrench, remove the two
BHSCS securing the handle assembly to
the console assembly. See Figure 5.
Lower
Display
Cable
Upper
Display
Cable
Console
Assembly
Washers (4)
BHSCS (4)
Handle
Assembly
Figure 5
Heart Rate Cable
Console
Assembly
BHSCS
C. Carefully unplug the heart rate cable
connector. See Figure 5.
D. Carefully unplug the display connector. See
Figure 4.
E. Using a 5/32 Allen wrench, remove the four
BHSCS screws securing the console to the
console mount.
NOTE: The console will be
reinstalled onto the new console mount in
step
12C . See Figure 6.
Console
Console
mount
BHSCS
Screw
(4)
Lock Washer
(4)
Figure 6
Figure 7
Access
Hole
Block
Wheel
Bolt
Nut
5. Remove left wheel.
A. Place a block under the unit as shown in Figure 7.
B. Using a 7/16” wrench and a 5/32” Allen wrench,
remove the bolt and nut securing the left wheel
in place and remove the wheel. See Figure 7.
Figure 8
Coax Cable and
Power Cable with
male connector
Cables
Access
Hole
Feed cable down to the bottom
then back up to the access hole.
Measure out 30” of cable (see
step 6C), then tape cable to frame.
6. Route coax and power cable.
A. Locate the coax and power cable (F).
B. Tape the ends of the coax and power cable
together (making it easier to guide the cables
down the frame).
C. Measure out 30” of cable and then tape cable
to frame as shown in Figure 8.
D. Route the cable inside top of frame as shown
in Figure 8.