Facility Safety Precautions
• Instruct all users on how to clip the e-stop clip onto their clothing and carefully test it prior to using
the treadmill.
• Instruct all users to use caution when mounting and dismounting the treadmill.
• Use a dedicated line when operating the treadmill. A dedicated line requires one circuit breaker per
unit.
• Connect the treadmill to a properly grounded outlet only.
•
DO NOT
operate electrically powered treadmills in damp or wet locations.
• Keep the running belt clean and dry at all times.
•
DO NOT
leave the treadmill unattended when plugged in and running.
Note:
Before leaving the treadmill unattended, always wait until the treadmill comes to a
complete stop and is level. Then, turn all controls to the STOP or OFF position and remove the
plug from the outlet. Remove the e-stop key from the treadmill.
• Immobilize the treadmill (when not in use) by removing the e-stop key.
• Inspect the treadmill for worn or loose components before each use. Do not use until worn or damaged
parts are replaced.
• Stop and place the treadmill at 0 degrees incline (level) after each use.
• Maintain and replace worn parts regularly. Refer to “Maintenance” section of Owner’s Manual.
•
DO NOT
operate the treadmill if: (1) the cord is damaged; (2) the treadmill is not working properly or
(3) if the treadmill has been dropped or damaged. Seek service from a qualified technician.
•
DO NOT
place the cord near heated surfaces or sharp edges.
•
DO NOT
use the treadmill outdoors.
•
DO NOT
operate the treadmill around or where aerosol (spray) or where oxygen products are being
used.
• Read and understand the Owner’s Manual completely before using the treadmill.
• Ensure all users wear proper footwear on or around all Cybex equipment.
• Set up and operate the treadmill on a solid, level surface. Do not operate in recessed areas or on
plush carpet.
• Provide the following clearances: 19.7 inches (0.5 m) at each side, 79 inches (2.0 m) at the back and
enough room for safe access and passage at the front of the treadmill. Be sure your treadmill is clear
of walls, equipment and other hard surfaces.
• Disconnect power before servicing.
•
DO NOT
attempt repairs, electrical or mechanical.
Seek qualified repair personnel when servicing. If you live in the USA, contact Cybex Customer
Service at 888-462-9239. If you live outside the USA, contact Cybex Customer Service at
508-533-4300.
• Use Cybex factory parts when replacing parts on the treadmill.
•
DO NOT
modify the treadmill in any way.
•
DO NOT
use attachments unless recommended for the treadmill by Cybex.
• Ensure all User and Facility Safety Precautions are observed.
Warning Decals
Warning labels indicate a potentially hazardous situation that could result in serious injury or death if
the precautions are not observed.
Page 6 of 88
Cybex 625T Treadmill Part Number LT-23221-4 H
Содержание 625T
Страница 1: ...Cybex 625T Treadmill Owner s Manual Cardiovascular Systems Part Number LT 23221 4 H www cybexintl com ...
Страница 8: ...Page 8 of 88 Cybex 625T Treadmill Part Number LT 23221 4 H ...
Страница 88: ...10 Trotter Drive Medway MA 02053 888 462 9239 508 533 4300 FAX 508 533 5183 www cybexintl com ...
