CYBEX 515T, Руководство пользователя

Страница: 96 / 104

Cybex Sport+ Treadmill Owner’s and Service Manual
Service
Page 7-38
D. Check to see that all of the connectors are connected firmly in their proper place.
E. Place the lower board shield in position and push the clips down. NOTE: The clips will
snap in.
8. Secure the left junction covers.
A. Using an Phillips screwdriver, tighten the three screws that hold the junction
covers in place.
9. Secure the motor cover.
A. Lower the motor cover center into position. See Figure 2.
B. Using a Phillips head screwdriver, tighten the three screws on each side. NOTE: Be
sure the screws are catching the center motor cover’s holes.
10. Secure the console back.
A. While being sure not to pinch any cables, attach the console back to the console front
with the five Phillips head screws.
Display Overlays
NOTE: This procedure will cover the upper and/or lower display overlay. They are removed
and replaced the same on the Cybex Sport+ treadmill.
Tools Required
• Phillips head screwdriver
• ESD (Electro Static Discharge) grounding strap
• Razor blade
1. Disconnect the external power source.
A. Turn the main power switch on the left side to the off (O) position.
B. Unplug the treadmill from the power outlet.
2. Remove the console back.
A. Using a Phillips head screwdriver, remove the nine screws that hold the console back
to the console front.
B. Gently pull off the console back.
C. Loosen the six screws that hold the front console in place. NOTE: This allow clearance
for the switch membranes to fit behind the handrail.
NOTE: The display board is susceptible to damage from a discharge of static electricity. While
handling parts underneath the console cover use an ESD grounding strap. This
eliminates the potential voltage (static) difference between you and the equipment you
are working on. Wear an ESD strap for the rest of this procedure.