CYBEX gold CLOUD Q with SensorSafe, Руководство пользователя

Страница: 20 / 62

ATTACHING INFANT CARRIER TO BASE
1. Make sure handle is LOCKED in the CARRY position.
2. Lift Infant Carrier by the Handle and slide the Attachment
Rod under the Attachment Catch on the Base.
3. Rotate foot end of the Infant Carrier down onto
the Base until an audible CLICK is heard.
4. Move handle to the DRIVE postion.
5. If the Infant Carrier is next to a vehicle door or panel, extend the
adjacent L.S.P. device. See page 44.
The green Safety Button will pop out from the middle of the Infant
Carrier Release to indicate proper attachment.
The Cloud Q is allowed to touch the vehicle seat(s) in front of it, as
long as the recline angle of the Cloud Q is not affected.
RELEASING INFANT CARRIER FROM BASE
If used, retract the L.S.P. device. See page 44.
1. Press the green Safety Button
a
in while pushing
the Infant Carrier Release down
b
.
2. Slightly tilt Infant Carrier toward front of vehicle.
Grasp Infant Carrier with both hands to lift off.
8. Press the Belt Tensioning Plate down with both
hands, where indicated, until it locks into place. The
orange Locking Lever will rotate to the CLOSE
position automatically when the Plate is locked.
If the Belt Tensioning Plate does not lock, try loosening the vehicle
belt slightly.
9. Grab the Base at the Belt Guides and pull from side to side
and front to back to make sure it is installed correctly. The Base
should not move more than 1 inch (2.5 cm) in any direction.
If the Base moves too much, open the Belt Tensioning Plate and
remove a little more slack from the vehicle belt, close Plate and
recheck. After this, if the Base still moves too much, you may need to
try a different vehicle seat location or installation method, or both.
10. Squeeze the Adjustment Handle on the Load Leg
and extend it until the Foot makes firm contact with
vehicle floor. Lock Leg into place using the first hole
that will firmly lock it against the vehicle floor.
It may be necessary to lift up slightly on the Base to allow the Foot to
lock into the hole. See page 30.
11. Check that the Recline Angle remained in the appropriate
range for the child's weight. If not, remove Base,
adjust recline angle and reinstall. See page 31.
Make sure that vehicle belt buckle and hardware DO NOT INTERFERE
with correct installation of the Base, or with the connection of the
Infant Carrier to the Base.
Automatic
DO NOT turn
38 37
a
b
Use the FIRST hole
that will lock the Load
Leg Foot firmly against
vehicle floor
10
Correct in vehicle
DRIVE handle position.
4
2
3
2
1
1
8
9
11
ALWAYS have the handle locked in the DRIVE position
while using this child restraint in a vehicle.
ALWAYS verify that the handle is LOCKED in the Carry
position before lifting Infant Carrier by the handle. An
unlocked handle could move unexpectedly, causing
child to fall out.
USING THE INFANT CARRIER WITH THE BASE INSTALLING THE BASE USING A LAP BELT ONLY
EN