If the remote control functions better when it is closer to
the unit, the battery may be running low.
In case of any leakage from the battery, dispose of the
battery right away and avoid touching the chemical
discharge. Make sure to clean the remote control’s battery
compartment before installing a new battery.
Operating the remote control
When using the remote control, be sure to stay within a 30
degree angle of the sensor on the receiver. Keep in mind that
any obstructions between the remote control and the receiver
will affect performance.
GETTING STARTED
Notes on battery
2
Place the battery into the holder as pictured below
with the POSITIVE SIDE (marked on Battery as “ +”)
facing upwards and insert into the remote control to
complete the battery installation.
30
30
2
7
2
+
Battery
+
To use the remote control
To replace the remote control’s battery, the battery holder must
be removed. Be sure to take note of the polarity marking on the
battery. The " + " side must face the bottom of the remote (the
side without any buttons).
To access the Battery, remove the Battery Holder
from the remote control. To remove the battery
holder, use your thumbnail to squeeze the Release
Clip in toward the center, while simultaneously
pulling the Handle out with your index fingernail, as
depicted below:
1
6
Replacing the remote control battery
The DVD player comes complete with a remote control. Just
pull the plastic tab in the remote control to activate the battery.
The plastic tab - which covers the battery terminals - extends
the life of the battery. *Please note that some models will not
include this plastic tab. If so please refer to the next section for
battery installation.
Remote Control
Plastic Tab
Pull
Remote Control
Handle
Release Clip
Battery Holder
TM
TM
/
+
-
