Installing the Singlewire InformaCast® RGB (Multi-Color) Strobe
Singlewire InformaCast® RGB (Multi-Color) Strobe Setup
Operations Guide
931633A
CyberData Corporation
29
2. On the
Network
page, enter values for the parameters indicated in
Note
The question mark icon (
) in the following table shows which web page items will be defined
after the
Toggle Help
button is pressed
.
Table 2-10. Network Configuration Parameters
Web Page Item
Description
Stored Network Settings
Addressing Mode
Select either DHCP IP Addressing or Static Addressing by marking the appropriate radio
button. DHCP Addressing mode is enabled on default and the device will attempt to
resolve network addressing with the local DHCP server upon boot. If DHCP Addressing
fails, the device will revert to the last known IP address or the factory default address if no
prior DHCP lease was established. See
Section 2.3.1, "Factory Default Settings"
for
factory default settings. Be sure to click
Save
and
Reboot
to store changes when
configuring a Static address.
Hostname
This is the hostname provided by the DHCP server. See the DHCP/DNS server
documentation for more information. Enter up to 64 characters.
IP Address
Enter the Static IPv4 network address in dotted decimal notation.
Subnet Mask
Enter the Subnet Mask in dotted decimal notation.
Default Gateway
Enter the Default Gateway IPv4 address in dotted decimal notation.
DNS Server 1
Enter the primary DNS Server IPv4 address in dotted decimal notation.
DNS Server 2
Enter the secondary DNS Server IPv4 address in dotted decimal notation.
Current Network Settings
Shows the current network settings.
IP Address
Shows the current Static IP address.
Subnet Mask
Shows the current Subnet Mask address.
Default Gateway
Shows the current Default Gateway address.
DNS Server 1
Shows the current DNS Server 1 address.
DNS Server 2
Shows the current DNS Server 2 address.
VLAN Settings
VLAN ID (0-4095)
Specify the IEEE 802.1Q VLAN ID number. Enter up to 4 digits. A value of 0 disables vlan.
Note
: The device supports 802.1Q VLAN tagging support. The switch port connected to
the device will need to be in “trunking mode” for the VLAN tags to propagate.
VLAN Priority (0-7)
Specify the IEEE 802.1p VLAN priority level. Enter 1 digit. A value of 0 may cause the
VLAN ID tag to be ignored.
Click the
Save
button to save your configuration settings.
Click on the
Reboot
button to reboot the system.
Click on the
Toggle Help
button to see a short description of some of the web page items.
First click on the
Toggle Help
button, and you will see a question mark (
) appear next to
some of the web page items. Move the mouse pointer to hover over a question mark to
see a short description of a specific web page item.
