CyberData 11035, Руководство по эксплуатации

Страница: 48 / 84

Installing the VoIP Emergency Intercom
Parts List
Operations Guide 930279M CyberData Corporation
41
2. On the Sensor Configuration page, enter values for the parameters indicated in Table 2-13 .
3. After changing the parameters, click Save Settings .
Table 2-13. Sensor Configuration Parameters
Web Page Item Description
Door Sensor Settings
Door Sensor Normally Closed Select the inactive state of the door sensors.
Door Open Timeout (in seconds) Select the number of seconds that you want to pass before
the door sensor is activated.
Flash Button LED* Check this box to flash the LED until the sensor is
deactivated (roughly 10 times/second).
Activate Relay Check this box to activate the relay until the sensor is
deactivated.
Play Audio Locally Check this box to loop an audio file out of the Intercom
speaker until the sensor is deactivated.
Play Audio Remotely Check this box to call a preset extension and play a pre-
recorded audio file (once).
Dial Out Extension Enter the desired dial-out extension number. For
information about dial-out extension strings and DTMF
tones, see
Section 2.3.5.1, "Dial Out Extension Strings and
DTMF Tones (using rfc2833)" .
Use this button to test the door sensor.
Intrusion Sensor Settings
Flash Button LED* Check this box to flash the LED until the sensor is
deactivated (roughly 10 times/second).
Activate Relay Check this box to activate the relay until the sensor is
deactivated.
Play Audio Locally Check this box to loop an audio file out of the Intercom
speaker until the sensor is deactivated.
Play Audio Remotely Check this box to call a preset extension and play a pre-
recorded audio file (once).
Dial Out Extension Enter the desired dial-out extension number. For
information about dial-out extension strings and DTMF
tones, see
Section 2.3.5.1, "Dial Out Extension Strings and
DTMF Tones (using rfc2833)" .
Use this button to test the Intrusion sensor.
Click the Save button to save your configuration settings.
Note : You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.