Installing the VoIP Intercom
Intercom Setup
Operations Guide
930242A-D
CyberData Corporation
32
Note
You can change the
Speaker Volume
and
Microphone Gain
without rebooting the device.
You must save and reboot the device for other changes to take effect.
Enable Push to Talk
This option is for noisy environments. When enabled, the
microphone will be muted normally. When the button is
pressed and held, it will unmute the microphone and allow
the operator to send audio back.
NOTE
: When
Enable Push to Talk
is enabled, you cannot
stop an active call with the call button. The device on the
other end will need to end the call.
NOTE
:
Enable Push to Talk
will not work on some older
hardware.
Volume Boost
When
Volume Boost
is enabled, the device will play at a
higher volume at the risk of having the audio clip at very
high levels.
Click the
Save
button to save your configuration settings.
Note
: You need to reboot for changes to take effect.
Click on the
Test Audio
button to do an audio test. When
the
Test Audio
button is pressed, you will hear a voice
message for testing the device audio quality and volume.
Click on the
Test Relay
button to do a relay test.
Click on the
Test Microphone
button to do a microphone
test. When the
Test Microphone
button is pressed, the
following occurs:
1. The device will immediately start recording 3 seconds of
audio.
2. The device will beep (indicating the end of recording).
3. The device will play back the recorded audio.
Click on the
Reboot
button to reboot the system.
Table 2-7. Device Configuration Parameters (continued)
Web Page Item
Description