
Installing the VoIP Intercom
Intercom Setup
Operations Guide
930242A-D
CyberData Corporation
21
2.1.7.2 Intercom with a Jumper and No RTFM Button
1. If you have an Intercom with a jumper and no RTFM button, then install a jumper on JP11. See
JP11
in
Figure 2-11
.
2. Wait until the IP address is announced.
3. Remove the jumper and restart the unit.
Figure 2-11. Jumper on JP11
2.1.8 Restore the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state. To restore the factory default settings on your device, do one of the following:
•
If you have an Intercom that has an RTFM Button, then see
Section 2.1.8.1, "Intercom with an
RTFM Button"
.
•
If you have an Intercom that has a jumper and does not have an RTFM button, then see
Section
2.1.8.2, "Intercom with a Jumper"
.
Note
Each Intercom is delivered with factory set default values.
Note
The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).