CyberData 010881, Руководство по эксплуатации

Страница: 13 / 38

Implementing the VoIP Zone Controller
Setting up the VoIP Zone Controller
VoIP Zone Controller 4-Port Audio Out Operations Guide 930109C CyberData Corporation
7
2.3.4 Restore the Factory Default Settings as Required
The VoIP Zone Controller is delivered with factory set default values for the following parameters.
Use the
RTFM
switch (see Figure 2-5 ) on the back of the unit to restore these parameters to the
factory default settings.
Figure 2-5. RTFM Switch
Note When you perform this procedure, the factory default settings are restored for all the
following parameters.
To restore these parameters to the factory default settings:
1. Press and hold the RTFM switch until the paging lights come on.
2. Continue to hold the RTFM switch after the lights go off.
3. Continue to hold the RTFM switch until the audio lights come on a second time (approximately
10 to 12 seconds).
4. Release the RTFM switch.
5. Wait for approximately five seconds.
6. Power down the device.
7. Wait for approximately 10 seconds.
8. Power on the device. The unit should now be restored to factory defaults.
Parameter Factory Default Setting
IP Addressing static
IP Address 192.168.3.10
Subnet Mask 255.255.255.0
Default Gateway 192.168.3.1
Username admin
Password admin