Dependent on use, the on/off switch may not last for the life
of the saw. If the switch fails in the off position, the saw may
not start. If it should fail while the saw is runn· the saw
may not turn off.
If one of these occurs, unplu he power
tool immediately and do not use it until repaired.
This saw should not be used as, or mounted to, a table saw.
This saw is not intended to be used as a table saw.
Kickback definition and related warnings
Kickback is the sudden reaction of the tool, when the blade
is pinched, bound or misaligned. Kickback causes an
uncontrolled saw to lift out from the work piece and jump
towards the operator.
When a blade is bound tightly or pinched by the cut of the
wood closing down, the blade can become stalled and the
motor reaction to this causes the tool to quickly move back
towards the operator.
Kickback is the result of misuse and/or incorrect procedures
and conditions. By taking some precautions, kickback can be
avoided.
Maintain a firm grip with both hands on the saw and position
you
v
a11d ,urns in a way that allows you to resist the
fore
kickback. Alwa stand to either side of the blade
and never in line with
blade.
If the blade becomes bound, or is interrupting a cut, release
the trigger and hold the saw in position until the blade comes
to a
Never attempt removing the saw or
bringing
rds while the blade is in motion or
kickback will most likely occur. Determine the cause and take
corrective action to eliminate the cause of binding.
When restarting the saw in a work piece, ensure that the saw
blade is centered in the cut and is not contacting the material
to be cut.
If the saw blade is obstructed upon restart, the saw
may kickback.
Large panels of material should be supported properly to
minimize pinching and avoid kickback.
Large panels tend to
bend under their own we
. Supports should be placed
under the panel on both s des, near the cutting line and the
edge of the material.
9
