A WARNING
As the blade enters the material, ensure you release the
trigger actuated lower guard, to allow the lower guard to
immediately cover the blade after the cut.
When the foot
rests flat on cutting surface, proceed cutting forward.
Never pull the saw backward since the blade will climb
out of material and KICKBACK.
If the corners of your
plunge cut are incomplete use a jigsaw or hand saw to
finish the cut.
Cutting Large Sheets
Large sheets and long boards will sag or bend without proper
support. Place support under the material close to the area
being cut. Set the proper depth so the blade doesn't cut the
workbench or table. Ensure the support is stable and even. If
the material is too large to place on workbench or saw
horses, place support 2x4 on floor and secure. Improper
support may lead to binding and kickback.
Rip Cuts
Rip cuts are done by cutting with the grain of the wood, using
a rip fence (provided) will ensure a straight cut, but is not
required. Attach the rip fence by sliding into side slots and
securing with bolts.
21
