Bevel Adjustment
quadrant located in
front of saw.
Release lever will ratchet the quadrant
loose and allow it to be tightened.
Figures
7
3a and b. Adjust bevel by locating release, lift up
locking pin and adjusting angle of blade to the desired cut.
90 Degree Cutting Angle Check
Disconnect the tool from power source.
Set to desired or
maximum cut depth setting. Loosen the bevel adjustment
lever and set the bevel adjuster to 0
°
. Check for 90
°
by placing
a square between the bottom of the base plate and the blade.
Guide Line
The guide line is located on the top of the front dust cover to
help make straight standard cuts. When the dust cover is
removed for cuts requiring zero-clearance, press the saw
flush against the opposing edge of the material. This will
allow the blade to guide itself straight and flush along the
path of the material as the saw moves forward in the cut.
Control Switch
To power "ON" the tool, squeeze the trigger switch. To turn
"OFF" the tool, release the spring loaded trigger, which will
automatically reset the switch to the "OFF" position. When
the switch is set from "ON" to "OFF" a brief moment of
reverse polarity is sent to the motor which acts as a motor
brake.
Figure
7
4. Rear handle and
control switch.
19
