Install the Brew Heads
Install the brew head assemblies into the countertop in the
correct position. One brew head is designed to be installed
on the right side and the other on the left. The installation
position for each brew head is marked on the attached wires
and tubes. Each brew head has three 1/4–20 studs with
matching nuts and washers for mounting onto the surface of
the counter.
10 Hold a brew head over the group of holes that matches
the markings on the brew head tubing/wiring (right or
left).
11 Insert the tubes and wires into the large center hole and
insert the studs through the three smaller holes, while
pushing the unit down onto the counter top.
12 Secure using one (1) fender washer, one (1) lock washer
and one (1) nut per threaded stud. Repeat for the other
brew head.
INSTALLATION INSTRUCTIONS
II12
CAUTION:
Do not open the brew head units! The
MFOHUIPGUIFXJSFTBOEUVCJOHBSFmYFEBOETFUBUUIF
factory. Do not splice or extend the tubes that come
from beneath the brew head assembly. Ample tube
length is provided and the tubes will need to be
shortened in most cases for proper installation.
Figure 6 - Brew Head Installation
SERA2, INSTALLATION INSTRUCTIONS
040220C
Inset frame, inset
installations only
Pipe
nipple
Barbed
elbow
Inset cutout,
inset installations
only
'UDLQKROHÀXVK
installations or fully
enclosed inset installations
Figure 5 - Drip Tray Installation
Install the Drip Tray
8 After preparing the drip tray location, according to Step
BQQMZ5FnPOQMVNCJOHUBQFUPUIFUISFBETPGUIF
supplied pipe nipple (or barbed elbow)* and thread into
the bottom of the drip tray. Assemble the drip tray pieces
as shown and place them into position.
*The elbow may only be used on drip tray installations
that are open wide enough on the bottom to allow access
to the barb connection.
9 Install the drain system. Be sure to allow room under the
countertop for the water tower.
