Curtis Dyna-Fog TWISTER XL 3 3950, Инструкция по установке, эксплуатации и техническому обслуживанию

Страница: 9 / 61

9
RUN
STOP
WORKING
IDLE
SPEED
THROTTLE
CONTROL
ENGINE
KILL
SWITCH
Honda GX-35 Engine Operation Instructions
FUEL
Check the fuel level by looking
through the translucent fuel
tank. If the fuel level is low,
refuel in a well-ventilated area
with the engine stopped. If the
engine has been running, allow
it to cool.
STARTING INSTRUCTIONS
Read and understand operation
manual before attempting to
operate machine.
1. Set throttle lever to idle speed. (bottom right diagram)
2. Set ignition switch (engine kill switch) to ON (Run) position (bottom right).
3. Depress priming bulb several times to purge air in the carburetor, until the flows trough
return pipe (bottom left diagram).
4. Pull choke lever upward to choke position/closed (bottom center diagram).
5. Pull recoil starter briskly, taking care to keep the handle in your grasp and not allowing it
to snap back.
6. When you hear the engine want to start, return the choke lever to the run position
(open). Then pull recoil starter briskly again.
Note: If engine does not start,
repeat procedures 4 to 6.
7. After starting, allow the
engine to warm-up 2 to
3
minutes (at idle
speed) before
operating at higher
speeds for fogging
operations.