Curtis Dyna-Fog TWISTER XL 3 3950, Инструкция по установке, эксплуатации и техническому обслуживанию

Страница: 34 / 61

34
TROUBLE SHOOTING GUIDE
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1) Recoil Starter Fails
to Crank the Engine
2) Engine Hard to Start
or Stops.
3) Engine Misses or
Runs Erratically
4) Engine Knocks or
Develops Noise
5) Engine does not Idle
Smoothly
6) Engine Overheats a) Defective recoil starter
b) Belt transmission with
obstructions.
c) Engine locked up.
d) Blower locked up.
a) Start – Stop switch on speed
control in stop position.
b) Faulty Start – Stop Switch on
speed control.
c) No fuel or contaminated fuel.
d) Clogged fuel filter.
e) Spark plug faulty.
f) Terminal loose or wiring
defective.
g) Spark plug wire disconnected.
h) Loosen gasoline hose or
perforated gasoline hose.
a) Start – Stop switch on speed
control in stop position.
b) Faulty Start – Stop Switch on
speed control.
c) No fuel or contaminated fuel.
d) Clogged fuel filter.
e) Carburetor mounted gasket
leaks.
h) Vacuum created inside fuel tank.
a) Spark arrestor clogged.
b) Flywheel loose.
c) Shaft adaptor/pulley loose.
d) Broken rotary fan at blower.
a) Carburetor dirty or out of internal
adjustment.
a) Fuel without 2 cycles oil (Tanaka)
b) Exhaust restricted.
c) Spark arrestor clogged.
d) Dirty cooling fins. a) Check recoil starter. Service it if
required.
b) Check belt and pulleys for
obstructions.
c) Check the engine for rotation.
Consult the nearest service center.
d) Inspect blower for rotation.
Consult the nearest service center.
a) Place switch in “ON” or “RUN”
position.
b) Replace faulty switch.
c) Add fuel or clean tank and refuel.
d) Clean filter (if possible) or replace it.
e) Clean or replace spark plug.
f) Tighten loose terminals, replace
defective wiring.
g) Connect spark plug wire.
h) Tighten loose clamps or change the
gasoline hose.
a) Place switch in “ON” or “RUN”
position.
b) Replace faulty switch.
c) Add fuel or clean tank and refuel.
d) Clean filter (if possible) or replace it.
e) Tighten bolts, replace gasket if
required.
h) Loosen the fuel tank cap, if
improves, check or replace tank vent.
a) Clean or replace.
b) Consult nearest service center.
c) Consult nearest service center.
d) Check blower and consult nearest
service center.
a) Clean and check carburetor.
a) Always use gasoline with 2-cycles
(Tanaka) oil, proportion of 50:1.
b) Clean or replace muffler.
c) Clean or replace.
d) Clean fins.